Friday, August 18, 2017

Mini Thankyou ......

Another little 3 x 3 inch card in my series ......

I used diecut papers, Washi tape, Stamp (Papertrey Ink) with Versafine black ink & adhesive gems. Some elements were raised on foam pads to add dimension.

Sid xx

Pin It

Thursday, August 17, 2017

London Bus .....

Here is a one layer card, made for a challenge over on the Less Is More Challenge Blog whose subject this week is 'Vehicles'

Also for the Naughty or Nice Challenge Blog whose theme this week is  'On The Move'.

I used a stamp set from Artemio, stamped the images in Versafine black and Memento dye ink.  I then added some ink spatters in blue and red and used a black Micron pen to add an outlines.

Sid xx

Pin It

Birdie Birthday .....

Made a birdie Birthday Card today .....

Started with a 6 x 6 inch white card blank and made a panel using Distress Inks & Distress Oxides with stamps, stencils and sprays.  This was trimmed and matted on printed paper.  The bird was diecut from some card decorated with printed papers and assembled on foam pads on a branch which was stamped in Versafine black ink on the panel. His beak was coloured black and a black gem added as an eye.

Another panel was stamped with the sentiment and again matted and placed as shown on foam pads.

Some orange flat backed gems were added to finish the card.

Sid xx

Pin It

Wednesday, August 16, 2017

Buildings ......

We run a monthly postcard Swap over on UK Stampers Forum - this months theme is 'Buildings' ...

I started with a 6 x 4 inch piece of white card as the base.  I then used Distress Oxide in walnut stain & vintage photo and stamped lots of times with a distressed spots stamp from Prima.  I then sprayed with small amounts of water and continued to stamp to blend the two colours until I obtained the finish I liked.

I then stamped some text (PaperArtsy) in Versamark and heat embossed this with detail black embossing powder.

I then used a Magenta stamp and stamped this in Memento black onto more white card.  I trimmed this out and coloured selectively with a gold Posca pen. This was stuck in place with Glossy Accents.

The words (PaperArtsy) were stamped in Memento black onto paper, trimmed out, stuck in place and decorated with a yellow Posca pen which also edged the words, main image and dots around the card.

I used dark brown Versamagic chalk ink to edge the card.  The whole thing was mounted on another layer of card to finish.  I then sprayed with matt acrylic sealant to protect.

It travels through the post 'naked' to its randomly chosen recipient at the end of Month.  If you like the idea of joining this and other Swaps, please click HERE to go to the Forum and join us !

Sid xx

Pin It

Tuesday, August 15, 2017

Mini 'Hello' .....

Another 3 x 3 inch mini card in my series !

Took a white card blank and decorated this with a circle of printed paper, added two strips of Washi tape and a square of Kraft card stamped with a flower, matted on green card, tied round with bakers twine and mounted as shown on foam pads.

The sentiment (Papertrey Ink) was stamped in Versafine black on white card, trimmed and matted on more green card and mounted on foam pads.

Simply made .......

Pin It

Monday, August 14, 2017

Open Flowers .....

This birthday card is a very simple design .....

I took a 5 x 7 inch white card blank as the base.  I then stamped a number of leaves (PaperArtsy) and flowers (Sizzix) onto white cardstock using a variety of Memento dye ink colours.

These were trimmed out with a small border.  They were then assembled as shown, some on foam pads.  The flowers were centred with coloured pearl cabochons and the leaf veins drawn in with a black Micron pen.

The sentiment (Happy Little Stampers) was stamped on white card with Versafine black ink before diecutting out and placing on the card on foam pads.

Sid xx

Pin It

Sunday, August 13, 2017

Butterfly Birthday ......

Weather is not summery at all here in the UK so made this Summery birthday card to lift my spirits.

Started with a 5.5 x 5.5 inch white card blank.  I then diecut a slightly smaller stitched square out of white card.  I made a masterboard using a selection of acrylic paints and from this diecut the butterfly saving the cut outs..

I then diecut 3 concentric stitched circles  in black, teal & lemon.  I reused the aperture made by diecutting the butterfly and diecut this with a circle the size of the black circle as a backing.  The circles were then matted and the butterfly mounted back into the aperture leaving the wings free to move.  I hand drew in the antenna with a fine Micron pen.

The circular matt was attached to the centre of the square as shown and the butterfly cutouts applied in a pleasing manner.

The sentiment (Papertrey Ink) was stamped on white card in Versafine black ink, trimmed out and applied on foam pads and placed as shown.  Finally the white square was mounted on more foam pads onto the card blank to finish the card.

Sid xx

Pin It

Saturday, August 12, 2017

Get Well .....

I do like these mini cards - they are just 3 x 3 inches in size. Limited space but you can do so much with the design for them !

This one started life as a white card blank.  I then diecut a stitched square and matted this on to a piece of slightly larger green cardstock.  I diecut out a circle in the centre of the square.  I then diecut another circle of printed paper with a matching colour theme.

I mounted the matted square centrally on the card front on foam pads and stuck the printed circle into the aperture.

I stamped the 'Get Well' (Papertrey Ink) onto white card in Versafine black in, trimmed out and applied on foam pads into the centre of the aperture to finish.

Simple, small but meaningful non the less !

Sid xx

Pin It

Friday, August 11, 2017

Black Tag .......

Here is a tag I made for a Swap over on UK Stampers Forum Facebook Group.

I took black card and cut it into a tag shape. This was stamped with Distress Oxide inks in wilted violet and faded denim then spritzed and dried.  I selectively added more of the inks until the intensity was to my liking before thoroughly drying with the heat gun.

I then diecut a number of flower dies, a lattice and the word from thin white card. These were coloured with a waterbrush and more Distress Oxide ink & were dried before adhering to the card as shown.  Some edging with white pen was done and crystal Stickles was applied on the flowers and word.

Final touches were to apply a black brad with the Cropodile and thread through with some silk fibres in contracting colours to finish.

I have entered this into the 'Happy Little Stampers' Challenge for this month whose theme is 'Anything Goes with Dies'

Sid xx

Pin It

Thursday, August 10, 2017

Happy Bird Day ......

A bright and cheerful Birthday card from me today ......

I started with a white card blank and diecut two smaller oblong stitched edge plates.  I then stamped the branch (Versafine black ink) and leaves (Versamagic chalk ink) once on the card and once on the larger matt which was mounted on foam pads directly over the original image on the card.

I used Memento inks to stamp the elements of the bird onto white card and then diecut these out.  The bird was then applied to the branch.

The words were stamped in Versafine black on the smaller matt and applied again on foam pads. Three adhesive gems were added to finish.

Sid xx

Pin It
Related Posts Plugin for WordPress, Blogger...